utils_docker_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
utils_docker_setup [2020/05/08 17:45] xavier |
utils_docker_setup [2020/05/08 19:15] (current) xavier [Limit docker resources usage] |
||
|---|---|---|---|
| Line 58: | Line 58: | ||
| * Install docker-compose: | * Install docker-compose: | ||
| - | ''$ sudo apt-get install docker-compose''\\ | + | Replace the version number by the current latest official release found above, and run the commands:\\ |
| + | ''$ sudo curl -L "https://github.com/docker/compose/releases/download/1.25.5/docker-compose-$(uname -s)-$(uname -m)" -o /usr/local/bin/docker-compose''\\ | ||
| + | ''$ sudo chmod +x /usr/local/bin/docker-compose''\\ | ||
| + | Check installed version:\\ | ||
| + | ''$ docker-compose --version''\\ | ||
| ===== Configuration ===== | ===== Configuration ===== | ||
| ==== Limit docker resources usage ==== | ==== Limit docker resources usage ==== | ||
| + | It is possible to set resources limits using docker-compose, without starting a swarm service.\\ | ||
| + | This feature was previously available in version 2 of compose-file. Since version 3, a new "deploy" section has been set up, normally only for 'docker stack deploy' feature, but then a --compatibility mode was added to docker-compose, so that it does not ignore information in the "deploy" section.\\ | ||
| + | To run a docker-compose.yml file above version 3 with resource limits, just run it like:\\ | ||
| + | ''$ sudo docker-compose --compatibility -f docker-compose.yml up -d''\\ | ||
utils_docker_setup.1588959900.txt.gz · Last modified: 2020/05/08 17:45 by xavier
Page Tools
